- ελληνικά
- Esperanto
- Afrikaans
- tiếng Việt
- Català
- Italiano
- שפה עברית
- Cymraeg
- العربية
- Gaeilge
- Türkçe
- Latviešu
- беларускі
- Français
- български
- český
- Eesti Keel
- Galego
- Indonesia
- Español
- русский
- Nederlands
- Português
- Norsk
- 日本語
- 한국어
- Lietuvos
- Pilipino
- ภาษาไทย
- Română
- icelandic
- Polski
- ייִדיש
- Hrvatski
- Deutsch
- Dansk
- Suomi
- Shqiptar
- український
- magyar
- Malay
- Slovenski
- lugha ya Kiswahili
- አማርኛ
- Frysk
- ગુજરાતી
- ಕನ್ನಡ
- Corsa
- Svenska
Let everyday plastic products not be easy to demould
2019-01-09
Everyday plastic products can be produced through molds. Everyone should be familiar with them. The molds are designed for mass production. When using molds for production, it is necessary to determine the quality of the molds. Only good molds can make the quality of everyday plastic products better!
The mold grade for producing daily plastic products should reach the "mirror level". Otherwise, it will make the daily plastic products difficult to demould. When we push out the daily plastic products, we need to use the appropriate strength, and the strength will be too large. Cause damage, strength is too small, and can not take it out, so it still needs to be appropriate!
The mold grade for producing daily plastic products should reach the "mirror level". Otherwise, it will make the daily plastic products difficult to demould. When we push out the daily plastic products, we need to use the appropriate strength, and the strength will be too large. Cause damage, strength is too small, and can not take it out, so it still needs to be appropriate!
